Suction Bell Mouth

Suction Bell mouth is one port piping component. This fitting is available in the Metric Catalogs. The Suction Bell Mouth value ranges from 150 mm to 350 mm .

Accessed from : Piping > Piping Galleries > Fittings > Suction Bell Mouth

The following parameters are mapped with the OpenPlant Modeler Schema and Spec.

COMP_LEN: COMP_LEN represents the length of the suction bell mouth. This field is mapped with the "LENGTH" property in schema.
COMP_OD: COMP_OD represents the outer diameter of non-connecting end of suction bell mouth, EC property "Bell mouth diameter" is mapped with this field.
HGHT_HEAD: HGHT_HEAD represents the length of cylinder at non-connecting end of suction bell mouth. An EC property "EXTENSION LENGTH" is mapped with this field.

Note: A cone and a cylinder are used as primitives to construct the geometry of the Suction Bell Mouth.

You can Check-in component or Check-out component to PlantSight.